Snap Lock: a hydrostatic standing seam roof with no exposed fasteners.
Field-installed panels with a snap-together seam, engineered so the metal surface itself sheds water — no reliance on underlayment to do the primary work.

Overview
Snap Lock is a standing seam roofing system where panels are formed with a male leg on one edge and a female leg on the other. Each panel is secured to the deck with concealed clips, and the next panel's female leg snaps directly over the installed panel's male leg and clip — creating a continuous vertical seam down the slope with no exposed fasteners anywhere on the finished surface.
Hydrostatic Design
Snap Lock is classified as a hydrostatic roofing system: it's designed to keep water entirely on the outside surface, handling standing and blowing water without relying on the panel seams themselves being fully watertight failsafes. The finished panel surface forms a contiguous, weathertight plane, backed by an appropriate underlayment for backside condensation — not as the primary line of defense against surface water the way a hydrokinetic system uses it.
As with any metal roof system, panel terminations, penetrations, and flashing details are the most common source of leaks and must be specifically detailed during design, not left to field improvisation.
Installation
Snap Lock panels install without specialized mechanical seaming tools — the panels lock together by hand pressure over the pre-installed clip, which shortens install time relative to mechanically seamed systems while still producing a clean, concealed-fastener finish. We fabricate Snap Lock in titanium, zinc, copper, and stainless steel, with panel width and seam height detailed to your project's specific slope and exposure conditions.
